۱.۱ This test method covers the determination of the relative solvent power of hydrocarbon solvents used in paint and lacquer formulations. This test method is suitable for use with solvents having an initial boiling point over ۴۰ °C and a dry point under ۳۰۰ °C when determined in accordance with the procedures in Note ۱.

۱.۲ For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E۲۹.

۱.۳ For specific hazard information and guidance, consult the supplier’s Material Safety Data Sheet.

۱.۴ The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

۱.۵ This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

۱.۶ This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.